JPexamは多くの人に便利を与えるとともに、多くの人の夢が実現させるサイトでございます。もし君はまだIT試験で心配すれば、私達JPexamの問題集を選んでください。JPexamは長年の研究をわたって研ITの認証試験に関する品質が高く、範囲は広い教育資料が開発しました。それは確かに君の試験に役に立つとみられます。
どうしてJPexamのJuniperのJN0-532試験トレーニング資料はほかのトレーニング資料よりはるかに人気があるのでしょうか。それはいくつかの理由があります。第一、JPexamは受験生の要求をよく知っています。しかも、他のどのサイトよりも良いサービスを提供します。第二、専心すること。我々が決まったことを完璧に作るためにすべての不要な機会を諦めなければなりません。第三、我々は確かに最高の製品を持っていますが、粗悪品の方式で表示されたら、もちろん粗悪品と見られますから、我々は自分の製品を創造的かつプロの方法で見せます。JPexamのJuniperのJN0-532試験トレーニング資料はこんなに成功するトレーニングですから、JPexamを選ばない理由はないです。
JN0-532認定試験に合格することは難しいようですね。試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。そうだったら、下記のものを読んでください。いまJN0-532試験に合格するショートカットを教えてあげますから。あなたを試験に一発合格させる素晴らしいJN0-532試験に関連する参考書が登場しますよ。それはJPexamのJN0-532問題集です。気楽に試験に合格したければ、はやく試しに来てください。
JPexamが提供した問題集を使用してIT業界の頂点の第一歩としてとても重要な地位になります。君の夢は1歩更に近くなります。資料を提供するだけでなく、JuniperのJN0-532試験も一年の無料アップデートになっています。
試験番号：JN0-532問題集
試験科目：FWV,Specialist (JNCIS -FWV)
最近更新時間：2014-02-05
問題と解答：全146問
100％の返金保証。1年間の無料アップデート。
君はまずネットで無料なJuniperのJN0-532試験問題をダウンロードしてから 弊社の品質を確信してから、購入してください。JPexamは提供した商品は君の成功を全力で助けさしたげます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.jpexam.com/JN0-532_exam.html
NO.1 Click the Exhibit button.
In the exhibit, what is the source IP address of the multicast traffic?
A.236.1.1.1
B.10.10.10.1
C.20.20.20.10
D.20.20.20.200
Answer: B
Juniper JN0-532 JN0-532過去問 JN0-532 JN0-532認定資格
NO.2 During main mode negations a failure has occurred while using IKE certificates.
Which message pair would you review to troubleshoot this failure?
A.messages 1 & 2
B.messages 2 & 3
C.messages 3 & 4
D.messages 5 & 6
Answer: D
Juniper問題集 JN0-532 JN0-532 JN0-532問題集
NO.3 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD
Juniper認証試験 JN0-532 JN0-532 JN0-532参考書
NO.4 Click the Exhibit button.
In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to
the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched
to DataCenter2.
Which statement explains this behavior?
A.SYN checking is enabled in the tunnel.
B.The weight value for the DataCenter2 is too high.
C.VPN monitor is misconfigured in the DataCenter2.
D.Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
Answer: A
Juniper JN0-532認定試験 JN0-532過去問 JN0-532認定試験
NO.5 Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
A.set igmp interface ethernet0/1
B.set multicast interface ethernet0/1
C.set interface ethernet0/1 igmp router
D.set igmp interface ethernet0/1 enable
Answer: C
Juniper参考書 JN0-532問題集 JN0-532 JN0-532過去問
NO.6 Which three OSPF parameters are interface parameters? (Choose three.)
A.cost
B.priority
C.neighbor list
D.summarization
E.advertise default route
Answer: ABC
Juniper問題集 JN0-532認証試験 JN0-532
NO.7 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD
Juniper認定証 JN0-532 JN0-532 JN0-532認定試験
NO.8 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D
Juniper JN0-532 JN0-532 JN0-532
NO.9 Which CLI command identifies the multicast sources visible to your ScreenOS device?
A.get route pim
B.get igmp source all
C.exec pim interface all query
D.get vrouter trust-vr protocol pim
Answer: D
Juniper認定資格 JN0-532 JN0-532練習問題 JN0-532参考書
NO.10 Click the Exhibit button.
In the exhibit, what is the address of the multicast receiver?
A.234.9.8.42
B.192.168.10.2
C.192.168.20.10
D.192.168.20.200
Answer: D
Juniper JN0-532認定証 JN0-532認定資格 JN0-532
NO.11 To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
A.zone
B.policy
C.interface
D.virtual router
E.virtual system
Answer: ACD
Juniper JN0-532 JN0-532認定試験
NO.12 Review the exhibit.
Which two of the following elements must be configured on the ScreenOS device in order to support
PIM-SM? (Choose two)
A.A multicast control policy
B.A bootstrap router process
C.A unicast routing protocol
D.A static RP
Answer: AC
Juniper認証試験 JN0-532 JN0-532認定資格 JN0-532 JN0-532 JN0-532過去問
NO.13 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
Juniper参考書 JN0-532認定資格 JN0-532認定証 JN0-532
NO.14 Click the Exhibit button.
Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in
the cluster:
Why has failover not occurred?
A.The physical interfaces have not failed.
B.The track-ip interval is not sufficient to cause failover.
C.The track-ip address weight is not sufficient to cause failover.
D.The track-ip address threshold is not sufficient to cause failover.
Answer: C
Juniper参考書 JN0-532 JN0-532
NO.15 Click the Exhibit button.
In the exhibit, which two can be determined about the VPN? (Choose two.)
A.NAT-traversal is enabled.
B.The rekey interval is 8 hours.
C.This device initiated the Phase 1 negotiations.
D.The certificate used in this exchange is set to never expire.
Answer: BC
Juniper参考書 JN0-532認定資格 JN0-532認定資格 JN0-532 JN0-532認定資格
NO.16 You have configured the following on your device.
set address trust MyPC 10.1.1.5/32
set address untrust CorpNet 10.10.0.0/16
set policy from trust to untrust MyPC CorpNet any permit
set int tunnel.1 zone untrust
set int tunnel.1 ip unnumbered int bgroup1
set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
set vpn VPN gateway GW sec-level standard
The tunnel interface is down, so the VPN cannot function properly. What is the problem?
A.The policy needs to have the action tunnel.
B.The VPN needs to be bound to the tunnel interface.
C.The tunnel interface needs to be placed in the trust zone.
D.The tunnel interface needs to be associated with the interface in the untrust zone.
Answer: B
Juniper JN0-532認証試験 JN0-532認定試験 JN0-532練習問題
NO.17 You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS
using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
What is the status of the virtual router after you create the VSYS?
A.The router will be the default router but will no longer be shared.
B.The router will be the default router and will still have a shareable status.
C.The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual
router must be private.
D.The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router.
The shared Virtual router will not be the default router.
Answer: B
Juniper認定試験 JN0-532 JN0-532認定資格 JN0-532認定資格
NO.18 Which three statements are true regarding IKE Phase 1? (Choose three.)
A.Placing the SA proposal list in message 1 is an option.
B.The digital certificate is used to decrypt the session key.
C.The DH key exchange is used to validate the session key.
D.The DH key exchange and digital certificates are both optional.
E.The proxy-id is used to determine which SA is referenced for the VPN.
Answer: ABC
Juniper問題集 JN0-532認定試験 JN0-532
NO.19 What must be enabled to protect Phase 2 key exchanges?
A.Phase 1 PFS
B.Phase 2 SHA
C.Phase 2 3-DES
D.Phase 2 DH key exchange tiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: D
Juniper過去問 JN0-532過去問 JN0-532過去問
NO.20 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C
Juniper練習問題 JN0-532 JN0-532認定証 JN0-532過去問
JPexamは最新の1Z0-597問題集と高品質のLOT-410問題と回答を提供します。JPexamのNS0-155 VCEテストエンジンとC4120-783試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の642-427 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论